• Print
• .

MK3 plates review

CONNECTORPLATE

Question from Bresto, 11/28/18

• are the 3 round holes correct?
• updated the D-shapes

Answer to Bresto:

• yes for the 3 holes at 16 mm
• checked size of N-type pass-thru, OK
• component dimensions: SMA-N 12.75x15.75, Arrestor N-N 13.5x15.75
• confirmed hole 13.7x16.1

21 Feb 2019: confirmed ready for production, quantity 50

DTACQSHELL

• produced 50, excess with D-Tacq, no further order

PABASEPLATE

PA_Heatplate_6mm

• use extruded plate as opposed to laser cut
• so possibly not Bresto but SiamMeca or emachine shop
• reduce length of 2 inner heat pipes and shift down (1/3 above 2/3 below)
• reduce length of outer heat pipe and shift to align with center heat pipe

WAIT!

SIDECHANNELLEFT

• shift upper and lower fan by 3/8" or 10 mm inward
• remove 3 upper PEMS

21 Feb 2019: confirmed ready for production, quantity 25

TOPSECTIONU

• criticism: standoff too rigidly placed
• no need for this complication on the PA side
• option: separate design for PA and recover existing RX U
• need to acomodate NUC, VSWR-PROT,

WAIT!

TOROIDPLATE

• unchanged

21 Feb 2019: confirmed ready for production, quantity 25

VENTCLOSE

• no more, try to cut hole in existing ones

Vicor_HeatPlate_6mm

• use extruded plate as opposed to laser cut
• so possibly not Bresto but SiamMeca or emachine shop
• reduce length of heat pipe and shift up
• reposition heat pipe to center VICOR
• remove upper VICOR drilling
• reduce VICOR holes to 6 each.

WAIT!

WALLMOUNTS

• 100 firm order 1842 EUR on 11/5/18 deliver 12/718 unchanged
• 20 Feb. confirmed ready for pickup

RAILDINL323

• unchanged

21 Feb 2019: confirmed ready for production, quantity 25

RAILDINL500

• unchanged

21 Feb 2019: confirmed ready for production, quantity 25

RXBaseP1, RXBaseP2

Summary of modifications requested 11/15

• shape of RX cards opening corrected for shorts (notch)
• modifications of the position of the central plate scews
• all holes tapped
• order 20

Answer from Bresto on 11/27 asking confirmation

• confirm shift 2 PEMS in lower plates and 1 PEM in upper plate
• confirm notches (4)
• confirm tap 36 holes

Review, missing:

• upper omega holes to short, need to extend downward
• update to 25 sets order (since excess receivers from Mexico)
• 20 Feb: gave corrected drawing from UH, need to add PEMS

21 Feb 2019: confirmed ready for production, quantity 25

RXSHIELD

• future

HEATSINKFANU

• future

EQUERREBIS

WAIT!