• Print
• .

MK3Parts

BOARDS

• Input Terminal
• Vicor Boards
  • resolder pads for L1, L2, L3, L4, L5
• Power Distribution
  • 12V/-12V models, output voltage can be set to 15V/-15V by connecting the output adjustment terminal TRM to -Vout.
  • Rup/R68 should be populated
• Analog Backplane
• LO Backplane
  • R93/R94 unpopulated
• LO Distribution
  • check R2 is 4992
• 8 Receiver Boards
• 8 Active Antennas

RX BOX

HEAT/VICOR Plate (2 sets, 8 Channel; 1 set, 4 Channel)

• Vicor Boards
  • 1 QTY EMI Gaskets, Sheets, Absorbers & Shielding EMI Shields
  • 1 QTY Isolated DC/DC Converters C 9/36/28 15v/ 6.67A
  • 1 QTY 4.991 kohm 1206 Resistor for rdown to set voltage down to 12.5 Volts from 15 Volts
• 2 SETS 12" QTY cable connector (2 red/2 black)
  • 1 EACH Ferrite Clamp On Cores Round 9mm Cable Clamp Filter
  • 1 EACH for black red Molex 19146-0035 Block Fork Terminal, #6 Stud, 16-14 AWG
  • 1 EACH Mini-Fit Jr. Series, Receptacle, 6 Positions, 4.2 mm
• 1 QTY EACH PER VICOR ROUND HEATPIPE 45W 6X200MM
• 1 QTY PER VICOR BOARD INPUT TERMINAL CONNECTOR
  • 1 EACH 7" Black [14-16AWG #6 Spade Terminal non-insulated >---< 14-16AWG #6 Spade Terminal]
  • 1 EACH 8" Red [14-16AWG #6 Spade Terminal non-insulated >---< 14-16AWG #6 Spade Terminal]
• 6 QTY m3 washers
• 6 QTY m3x20mm screws
• 6 QTY M3 x 9mm CLEARANCE BRASS 4.75mm O/D
• Input Terminal
  • 4 QTY m3 washers
  • 4 QTY m3x16mm screws
  • 4 QTY M3 x 9mm CLEARANCE BRASS 4.75mm O/D

CONNECTOR Plate

• 9 QTY SMA Female to N Female Bulkhead
• 1 QTY UHF Female to UHF Female Bulkhead
• 1 QTY UHF Angle Connector

TOP_SECTION BASE PLATE

• DTACQ
• 4 QTY Sorbathane Male/Female 0519411-50-4 M4, 12.7 mm(H), 50 duro USD 47.95 /4pack
• 4 QTY rubber mounts part number: 9241K42
• Fan Assembly
  • 1 QTY DC Fans 12Vdc 1.3W 16.3CFM DC Axial 60x60x10mm (cable twisted)
    • 4 QTY F-344-8012 BLACK FAN MOUNT
    • 1 QTY Headers & Wire Housings REC 02P CLOSED END
  • 1 QTY DC Fans DC Fan, 80x25mm 12VDC, Vapo, MagLev (cable twisted)
    • 4 QTY F-345-8 FAN MOUNT
    • 1 QTY FAN GUARD BLND HL MNT BLACK 80MM
    • 14" cable extension 24AWG black/red
    • 1 QTY Headers & Wire Housings REC 02P CLOSED END (cable twisted)
• LO distribution Board
  • 2 QTY CONN TERMINATOR PLUG SMA 50OHM
  • 2 QTY MCX to SMA adaptor
• Power Distribution Board
  • 1 QTY 2" POWER DISTRIBUTION HEADER for Active Antennas [14-16AWG #6 Spade Terminal non-insulated >---< [14-16AWG #6 Spade Terminal non-insulated ]
  • LO Backplane Power Cable (3 Black, 5 red)
    • 2 QTY Mini-Fit Jr. Series, Receptacle, 8 Positions, 4.2 mm
    • 1 QTY Ferrite Clamp On Cores Round 13mm Black Cable Clamp Filter
  • LO DISTRIBUTION Cable Power Connector (1 Red, 2 Black)
    • 2 QTY Mini-Fit Jr. Series, Receptacle, 4 Positions, 4.2 mm
    • 1 QTY Ferrite Clamp On Cores Round 7mmUSB Black Cable Clamp Filter
  • DTACQ Cable Power Connector
    • 1 EACH Mini-Fit Jr. Series, Receptacle, 6 Positions, 4.2 mm
    • 11" DC Power Connector
    • 2 PCS Socket, Crimp, 22 AWG, Tin Plated Contacts
    • 1 QTY Ferrite Clamp On Cores Round 4mmUSB Black Cable Clamp Filter

RXBASE PLATE

• 4 QTY M4x10
• 10 QTY 4mm x 5mm (8mm O.D.) spacers
• 10 QTY m3 x 12 mm
• 20 QTY m3 washers
• 38 QTY m3 x 3mm/4mm

SIDE CHANNEL LEFT PLATE Fan Assembly

• 1 QTY DC Fans Fan, 120x25mm, 12VDC Vapo, Auto Restart
  • 4 QTY F-345-8 FAN MOUNT
  • 1 QTY FAN GUARD BLND HL MNT BLCK 120MM
  • 1 QTY Headers & Wire Housings REC 02P CLOSED END

Cables and Connectors

• 1 QTY 5ft UHF (PL-259) Male cut to 30" + 10" RED/BLACK connector 2 PCS Fork Terminal, #10 Stud, 12-10 AWG + Ferrite Clamp On Cores Round 11mm Black Cable Clamp Filter
• 8 QTY RG316 SMA Male Right Angle to SMA Male Right Angle 24" custom here
• 1 QTY RG316 SMA Male Right Angle to SMA Male Right Angle 36" custom here + Ferrite Clamp On Cores Round 7mm USB Cable Clamp Filter
• 2 QTY RG316 SMA Male Straight to MCX Male Right Angle 30" RG316 SMA Male Straight to MCX Male Right Angle 34" custom here + Ferrite Clamp On Cores Round 7mm USB Cable Clamp Filter
• 1 QTY RG316 MCX Male Right Angle to MCX Male Right Angle 6" custom here
• 3 QTY RG316 MCX Male Right Angle to MCX Male Straight 9" custom here
• 1 QTY 1m VHDCI SCSI (SCSI-5) LVD/SE Cable - .8mm 68-pin VHDCI SCSI Male to Male + | Ferrite Clamp On Cores Round 10mm Black Cable Clamp Filter
• 1 QTY 24" 2.54mm to 2.00 mm 2-pin + Ferrite Clamp On Cores Round 7mmUSB Black Cable Clamp Filter

RX Grounding Connectors

• 1 QTY 12" DTACQ to RX Plate [ 14-16AWG M3 CRIMP o---o 12-10 GA 1/4 Ring Terminal ]
• 2 QTY 6" RX Plate to Connector Plate [ 12-10 AWG, #10 Ring Terminal o---o 12-10 GA 1/4 Ring Terminal ]
• 1 QTY 10" RX Plate to Door [ 12-10 GA 1/4 Ring Terminal o---o 12-10 GA 1/4 Ring Terminal ]
• 1 QTY 8" DOOR to female Bullet [ 12-10 GA 1/4 Ring Terminal o---D 12-10 Female Bullet Connector ]
• 1 QTY 8" DOOR to male Bullet [ 12-10 Male Bullet Connector D---o 12-10 GA 1/4 Ring Terminal]
• 1 QTY 20" INTERM to RX Plate 12-10 GA 1/4 Ring Terminal o---< 14-16AWG #6 Spade Terminal ]
• 1 QTY 4" INTERM to VICOR Plate 12-10 GA 1/4 Ring Terminal o---< 14-16AWG #6 Spade Terminal]

TX BOX

TOP_SECTION BASE PLATE

• 1 QTY DC Fans 12Vdc 1.3W 16.3CFM DC Axial 60x60x10mm
  • 4 QTY F-344-8012 BLACK FAN MOUNT

PA BASE PLATE

TRACO Power Supply (on DIN RAIL)

• TRACO Power 300 Watts with UDS or TRACO Power 300 Watts
  • 4 PORT 2 QTY 12" Green with 12-10 GA 1/4 Ring Terminal + 2 QTY 10.5" RED with 14AWG 0.47 Non Insulated
  • 3 PORT 1 QTY 11" BLACK with Ferrule 14AWG 0.47 Non Insulated + 1 QTY 11" WHITE with Ferrule 14AWG 0.47 Non Insulated + 1 QTY 7" GREEN with 12-10 GA 1/4 Ring Terminal
  • Fan Assembly
    • 1 QTY DC Fans DC Fan, 80x25mm 12VDC, Vapo, MagLev
    • 1 QTY FAN GUARD BLND HL MNT BLACK 80MM
• 4 QTY ROUND HEATPIPE 45W 6X200MM
• 1 QTY CIR BRK THRM-MAG 8A 240VAC/60VDC
• 1 QTY CIR BRK THRM-MAG 6A 240VAC/60VDC
• 1 QTY Industrial Relays 1 form C 16A 24VDC RED LED
  • 1 QTY 4" WIRE A1 <---> COM Ferrule 16AWG 0.47 Non Insulated
  • 1 QTY 6" WIRE COM 2 PCS Ferrule 14AWG 0.47 Non Insulated

HEATPLATE

• 1 QTY BTM00250-AlphaSA

Connector plate

• 1 QTY SMA Female to N Female Bulkhead
• 1 QTY UHF Female to UHF Female Bulkhead
• 1 QTY UHF Angle Connector
• 1 QTY Female to Female N Bulkhead Lightning arrestor
• 1 QTY N Angle Connector

TOROID PLATE

• 2 QTY 1/2" Washer
• 1 QTY LOCK NUT NYLON
• 1 QTY 1/2" x 3.5"
• 1 QTY Isolation Transformer 470VA 50-60Hz 2x117V Dual Secondaries

Cables and Connectors

• 1 QTY 5ft UHF (PL-259) Male cut to 14" + 10" BLACK(GREEN) connector with 12-10 GA 1/4 Ring Terminal and 10" RED with Ferrule 14AWG 0.47 Non Insulated + Ferrite Clamp On Cores Round 11mm Black Cable Clamp Filter
• 1 QTY RG316 SMA Male Right Angle to SMA Male Right Angle 42" custom here
• 1 QTY RG316 SMA Male Right Angle to SMA Male Right Angle 12" custom here
• 1 QTY RG142 SMA Male Straight to N Male Straight 24" custom here + Ferrite Clamp On Cores Round 10mm Black Cable Clamp Filter
• 1 QTY 6" RED + 5" RED 1 PC FERRULE NON-INS 10 AWG .59 ---=== 2 PCS Ferrule 14AWG 0.47 Non Insulated
• 1 QTY 6" BLACK + 5" BLACK 1 PC FERRULE NON-INS 10 AWG .59 ---=== 2 PCS Ferrule 14AWG 0.47 Non Insulated

TX Grounding Connectors

• 1 QTY 3" TOMCO to RX Plate [ 14-16AWG M3 CRIMP o---o 12-10 GA 1/4 Ring Terminal ]
• 2 QTY 6" RX Plate to Connector Plate [ 12-10 AWG, #10 Ring Terminal o---o 12-10 GA 1/4 Ring Terminal ]
• 1 QTY 10" RX Plate to Door [ 12-10 GA 1/4 Ring Terminal o---o 12-10 GA 1/4 Ring Terminal ]
• 1 QTY 8" DOOR to female Bullet [ 12-10 GA 1/4 Ring Terminal o---D 12-10 Female Bullet Connector ]
• 1 QTY 8" DOOR to male Bullet [ 12-10 Male Bullet Connector D---o 12-10 GA 1/4 Ring Terminal]

OPTIONAL PARTS

• DIN Rail Power Supplies 12W 5V 2.4A DIN-Rail
• DIN Rail Power Supplies 24W 12V 2A DIN-Rail

OTHER PARTS

• 5ft Type N Male to Type N Male (RG213) 50 Ohm Coaxial Cable Assembly (High-Power / Low-Loss)
• 5ft UHF (PL-259) Male to UHF (PL-259) Male (RG213) 50 Ohm Coaxial Cable Assembly (High-Power / Low-Loss)
• HDMI Water Proof HDMI Connector
• HDMI Cable hdmi cable
• RJ45 water proof RJ45 Connector
• RJ45 cable Cable

RECOMMENDED TOOLS/PARTS

• deburring Tool
• M3 tapper
• Thermal Grease / Compound
• locktite threadlocker blue
• locktite threadlocker red